Geely FC Workshop Manual page 189

Transmission—Disassemble assembly
Measure the round flop liking that shown in figure, its maxi-
mal allowed flop value is 0.03, if exceeding this value, it is
necessary to change the output shaft.
Check the axial clearance between the back surface of syn-
chronous loop and end surface of gear splines with clear-
ance gauge, its minimal value is 0.8mm, if the clearance is
less than this value, it is necessary to change the synchro-
nous loop.
Check the clearance between gear cover fork slot and fork
with clearance gauge, its maximal value is 0.35mm, if exceed-
ing this value, it is necessary to change fork.
Check the abrasion and damaged situation of output shaft,
and measure the exterior diameter of bearing platform with
micrometer, its minimal value is 33.985mm, if measured re-
sult is less than this value, it is necessary to change the out-
put shaft.
Assemble first gear and synchronous loop liking that shown
in figure.
178