Speed Sensor Of Rear Wheels; Change - Geely FC Workshop Manual

Speed sensor of rear wheels

Change

Hint: the process for changing right side is same as the
left side.
1. Disassemble rear wheels.
2. Disassemble wiring harness of speed sensor of rear
wheel.
Disassemble the joint of speed sensor of rear wheel.
3. Disassemble left rear disk brake branch pump
assembly.
4. Disassemble rear brake disk.
5. Disassemble left rear shaft hub and bearing assem-
bly (referring to page 129).
6. Disassemble speed sensor of rear wheel.
(a) Fix rear shaft hub on pliers with soft gasket.
Note: when changing shaft hub assembly, it is neces-
sary to shake intensively to make it break off.
(b) Use punch pin and hammer to knock out two pins.
(c) Use special tool and two bolts (M12*1.5) to disassemble
speed sensor of rear wheel from rear shaft hub.
Note:
If sensor stator is damaged, change the shaft hub
assembly.
Do not scratch the surface of shaft hub and speed
sensor.
7. Assemble speed sensor of rear wheels.
(a) Wash contacting surface of rear shaft hub and new speed
sensor of rear wheels.
(b) When sensor is assembled in shaft hub, it is necessary
to assemble sensor joint facing lower position of
automobile.
152
Brake--Speed sensor of rear wheels
Special
tool
Bolt
Bolt
Special tool