Fuel Tank Assembly; Removing, Installing And Disassembling, Assembling - Geely FC Workshop Manual

Fuel tank assembly

Removing, installing and disassembling, assembling

1. Take measures to prevent gasoline leaking
(see Page 14)
2. Remove rear seat cushion assembly
3. Remove rear floor repairing hole cover
4. Remove No. 2 fuel evaporation assembly
5. Remove fuel tank main fuel hose and oil return pipe
assembly
6. Remove fuel pump assembly
7. Discharge fuel
8. Remove front floor bracket
9. Remove front exhaust pipe assembly
(a) Move away carpet and remove oxygen sensor joint.
(b) Remove front exhaust pipe assembly
10.Disassemble the vent pipe of fuel hose
11.Disassemble filler pipe from fuel tank
12.Remove No. 2 fuel evaporator hose assembly
Press fuel hose joint and then pull out the hose.
Notes:
Check there is contaminant that looked like dirt around the
joint before operating and clean it off in the case of
contaminant.
Be careful of the contaminant that looked like dirt, because
fast-joint depends on o-ring to seal fuel pipe and joint.
Do not perform this operation with tools.
Do not bend or distort nylon hose.
Cover the joint with plastic bag after removing the fuel hose.
When the joint is stuck with fuel pipe, clip the hose with
fingers and rotate carefully to release the hose, and then
remove it.
13.Disassemble fuel tank main fuel hose assembly
Clip the protrusion part of fixing ring and move lock claw toward
open direction, and then pull out the hose as shown in the
diagram.
Notes:
Check there is contaminant looked like dirt around the joint
before operating and clean it off in the case of contaminant.
Fuel - Fuel tank assembly
Nylon pipe
O-ring
Fuel pipe clip
Pipe
21