Geely FC Workshop Manual page 130

(b) B type
Liking that shown above, set up the distance of absorber:
B type and C typ
27. Assemble fixing clamp of dynamic absorber of drive
shaft.
(a) Single-contact fixing clamp type:
Assemble new fixing absorber clamp on the absorber of drive
shaft, then fix the fixing clamp with screw driver.
(b) Mesh clasp type:
Assemble new fixing absorber clamp on the absorber of drive
shaft, then fix the fixing clamp with screw driver.
28. Assemble inner joint of left front drive shaft.
(a) Twist ethylene adhesive tape on gear slot of exterior joint to
prevent damage.
(b) Assemble following parts on drive shaft by sequence.
(1) No.2 fixing clamp of inner joint dustproof cover.
(2) Inner joint dustproof cover
(3) Fixing clamp of inner joint dustproof cover.
(c) Align the mark made before disassembly, and assemble
triangle joint in drive shaft.
(d) Assemble triangle joint assembly with copper stick and
hammer.
Note: do not knock the stator.
Drive shaft--Front drive shaft
470 ± 2mm
Single-contact fixing
clamp type
Mesh clamp type
Align the
mark
119