Electrical Adjustment; Memory Function Of The Electrically Adjustable Seat - Skoda Yeti Owner's Manual

Adjusting the tilt of the backrest (do not lean on the backrest when ad-
C
justing)
Setting the extent of the curvature of the lumbar support
D
Note
After a certain time, play can develop within the adjustment mechanism of the
backrest angle.

Electrical adjustment

Fig. 56 Control elements on the seat

Read and observe on page 70 first.
The seats can be adjusted by the respective operating element being pressed
in the direction of area of the arrow
seat adjustment
A
▶
1 - Move in the longitudinal direction
▶
2 - Change in inclination
▶
3 - Change in height
Adjusting the seat backrest
B
▶
4 - Change in inclination
Adjusting lumbar support
C
▶
5 - Change curvature
▶
6 - The degree of curvature change
WARNING
The electric front seat adjustment is functional even with the ignition off.
Therefore, when leaving the vehicle, never leave people who are not com-
pletely independent, such as children, unattended in the vehicle - there is a
risk of injury!
» Fig. 56.
Note
If the inclination angle of the seat backrest relative to the seat surface is
greater than 102 °, then it is not possible for safety reasons to save this setting
in the memory of the electrically adjustable seats or the remote control key.

Memory Function of the electrically adjustable seat


Read and observe on page 70 first.
Among the memory buttons on the driver's seat, a setting for the driver´s
B
seat and exterior mirror position can be saved
Storing driver's seat and exterior mirror settings for the forwards drive
›
Switch on the ignition, adjust the seat and the exterior mirrors.
›
Hold down the  » Fig. 57 button and within 10 seconds press the de-
A
sired memory button at the same time. Storing is confirmed by an acous-
B
tic signal.
Storing front passenger´s exterior mirror settings for reversing
Above the MAXI DOT display in the Mirror down menu item, the lowering func-
tion for the mirror on the passenger side must be enabled for reversing
» page 45, Menu item Settings.
›
Turn on the ignition and press the desired memory button
›
Turn the rotary knob for the exterior mirror control to the position for the
front passenger mirror area » page
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position.
›
Disengage reverse gear. The set position of the exterior mirror is stored.
Fig. 57
SET button and memory buttons
» Fig. 57.
» Fig. 57.
B
69.
Seats and head restraints

71