Table of Contents
Advertisement
Attaching the windscreen wiper blade
›
Slide the windscreen wiper blade in the opposite direction to arrow
locks into place. Check that the windscreen wiper blade is correctly attached.
›
Fold the windscreen wiper arm back to the windscreen.
›
Turn on the ignition and press the lever in the direction of the arrow
» Fig.
189.
The windscreen wiper arms move into the home position.
Replacing the rear window wiper blade
Fig. 191 Changing the rear window wiper blade
Read and observe
on page 168 first.
Removing the wiper blade
›
Lift the wiper arm
» page 169
from the window in the direction of arrow
» Fig.
191.
›
Tilt the wiper blade to the stop in the same direction.
›
Grip the wiper arm and press securing latch
.
2
›
Remove the wiper blade in the direction of the arrow
Attaching the windscreen wiper blade
›
Slide the windscreen wiper blade in the opposite direction to arrow
locks into place. Check that the windscreen wiper blade is correctly attached.
›
Fold the windscreen wiper arm back to the windscreen.
until it
3
1
down in the direction of arrow
A
.
3
until it
3
Fuses and light bulbs
Fuses
Introduction
This chapter contains information on the following subjects:
Individual electrical circuits are protected by fuses. A blown fuse is recognisa-
ble from the melted-through metal strip
WARNING
» page
144.
CAUTION
Replace the faulty fuse with a new one of the same amperage.
■
If a newly inserted fuse again blows after a short time, then seek assistance
■
from a specialist garage.
"Do not repair" the fuses and do not replace them with stronger fuses -
■
There is a risk of fire and damage to another electrical system.
Note
We recommend always carrying replacement fuses in the vehicle.
■
There can be several power consuming devices for one fuse. Multiple fuses
■
may exist for a single power consuming device.
Fig. 192
Blown fuse
» Fig.
192.
Fuses and light bulbs
170
170
171
171
169
Hide quick links:
Advertisement
Chapters
Table of Contents
