Tablet Holder - Skoda Yeti Owner's Manual

›
Place the empty through-loading bag in such a way that the end of the bag
with the zip is in the boot.
›
Push the skis and poles with the tips backwards into the through-loading
bag and secure the bag.
Securing through-loading bag and skis
›
Pull the securing belt with both lock tongues out of the pocket of the
through-loading bag.
›
Insert the lock tongues » Fig. 95
A
belt , first on the one side and then on the other side.
C
›
Place the securing belt in the middle of the skis between the heel and the tip
of the bindings and pull the securing belt tight at the free end of the belt
WARNING
The total weight of the skis which are transported must not exceed 10 kg.
■
Always stow and secure the skis and the bag securely - otherwise there is
■
a risk of injury or accident!
CAUTION
Never fold and stow the through-loading bag when it is wet -There is a risk of
damaging the through-loading bag.

Tablet holder


Introduction
This chapter contains information on the following subjects:
Attaching the rear headrests
Handle holder
External devices (e.g. tablet, smartphone, etc.) measuring min. 122 mm and
max. 195 mm can be secured in the support.
The maximum permissible load of the compartment is 750 g.
CAUTION
Never exceed the maximum permissible load of the holder - there is a risk of
damage or functional impairment.
86
Using the system
in the belt locks of the rear middle seat
Attaching the rear headrests
.
B
Fig. 96 Inserting: Adapter / holder
Fig. 97 Removing: Holder / Adapter

Read and observe
86
›
87
To insert, attach the opened adapter to the guide rods of the front headrest
and clip in the direction of arrow
›
Clip the holder in the direction of arrow
›
To remove, pull on the securing tab
holder in direction of arrow
›
Press the adapter and remove from the guide rods of the headrest in the di-
rection of arrow .
5
WARNING
Carefully clip in the adapter - there is a risk of injuring your finger.
on page 86 first.
» Fig. 96 » .
1
into the adapter.
2
in direction of arrow
A
out of the adapter » Fig. 97.
4
and take the
3