Skoda Yeti Owner's Manual page 61

WARNING
If the tilt / slide sunroof is closed, by pulling on the recess of the switch in
the direction of arrow , » Fig. 40
2
hindered by an obstacle, then at the third attempt at closing, the force limi-
tation will cease to function (if less than 5 s passes between the individual
attempts to close). The tilt / slide sunroof closes with full force - There is a
risk of injury.
Convenience operation of sliding / tilting roof

Read and observe and
The convenience operation makes it possible to open or close the sliding/tilt-
ing roof using the key or the KESSY system via the sensor in the door handle of
the front door.
›
To open out, press and hold the  button on the key.
›
OrHold the key in the unlock position in the driver's door lock.
›
To close, press and hold the  button on the key. In the KESSY system, hold
your finger on the sensor on the outside of the front door handle
page 51.
›
OrHold the key in the lock position in the driver's door lock.
By interrupting the locking process, the closing operation is interrupted.
Activate operation of the tilt / slide sunroof

Read and observe and
If the tilt / slide sunroof stops working (e.g. after disconnecting and connecting
the battery), then the operation must be reactivated.
›
Turn on the ignition and set the switch to position 
›
Press the switch on the recess E down and pull forwards.
The tilt / slide sunroof opens and closes again after around 10 seconds.
›
Release the lever.
on page 58 and the closing process is
on page 58 first.
on page 58 first.
» Fig. 40 on page 58.
Sunshade with electric operation

Read and observe
Operation of the sunblind
Open - by pressing (press again - sunshade stops moving)

Close - by pressing (press again - sunshade stops moving)

The sunshade can also be operated by pressing and holding the appropriate
button (starts movement of the sunshade) and releasing it when the sunshade
» Fig. 31 on
reaches the desired position.
Activating operation of the sunshade

Read and observe
If the operation of sunshade is deactivated (e.g. after disconnecting and con-
necting the battery), then the operation will have to be activated.
›
Turn on the ignition and set the switch to position 
›
Press the button  and hold down.
The sunshade opens and closes again after around 10 seconds.
›
Release the button.
Fig. 41
Button for operating the sun-
shade
and on page 58 first.
» Fig. 41
and on page 58 first.
» Fig. 41
Unlocking and opening
on page 59.
59