Electrical Adjustment; Memory Function Of The Electrically Adjustable Seat - Skoda octavia Owner's Manual

Electrical adjustment

Fig. 62 Control elements on the seat

Read and observe on page 75 first.
The seats can be adjusted by the respective operating unit being pressed in
the direction of area of the arrow
seat adjustment
A
▶
1 - Move in the longitudinal direction
▶
2 - Change inclination
▶
3 - Change height
Adjusting the seat backrest
B
▶
4 - Change inclination
Adjusting lumbar support
C
▶
5 - Change curvature
▶
6 - Change the degree of curvature
WARNING
The electric front seat adjustment is functional even with the ignition off.
Therefore, when leaving the vehicle, never leave people who are not com-
pletely independent, such as children, unattended in the vehicle - there is a
risk of injury!
Notice
If the inclination angle of the seat backrest relative to the seat surface is
greater than 102 °, then it is not possible for safety reasons to save this setting
in the memory of the electrically adjustable seats or the remote control key.
76
Using the system
» fig. 62.

Memory Function of the electrically adjustable seat


Read and observe on page 75 first.
Among the memory buttons on the driver's seat, a setting for the driver´s
B
seat and exterior mirror position can be saved
Storing driver's seat and exterior mirror settings for driving forward
›
Switch on the ignition, adjust the seat and the exterior mirrors.
›
Hold down the » fig. 63button and within 10 seconds press the desired
A
memory button at the same time. Storing is confirmed by an acoustic sig-
B
nal.
Saving front passenger mirror settings for reversing
The function of lowering the front passenger mirror area when reversing must
be enabled in Infotainment» Owner's Manual Infotainment.
›
Turn on the ignition and press the desired memory button
›
Turn the knob for the external mirror control to the position for the passen-
ger side mirror adjustment » page
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position.
›
Disengage reverse gear. The set position of the exterior mirror is stored.
Retrieving the saved setting
›
With the ignition off and the driver's door open-press- the desired memory
button B.
›
In other cases (e.g. if the ignition is switched on or the driver's door closed),
hold the button.
Stopping the current adjustment
›
Press any button on the driver's seat or the button on the remote control
key.
Fig. 63
SET button and memory buttons
» fig. 63.
» fig.
B
73.
63.
