Jump-Starting - Skoda Yeti Owner's Manual

If the tyre inflation pressure is 1.3 bar or more
›
Set the tyre pressure back to the correct value
›
Continue driving carefully to the nearest specialist garage at a maximum
speed of 80 km/h (50 mph).
WARNING
A tyre filled with sealant has the same driving characteristics as a standard
tyre. The following guidelines must be observed.
Do not drive faster than 80 km/h (50 mph).
■
Avoid accelerating at full throttle, sharp braking and fast cornering.
■

Jump-starting


Introduction
This chapter contains information on the following subjects:
Jump-starting using the battery from another vehicle
WARNING
The following instructions must be followed at all times when working on
■
the engine compartment » page
When handling the vehicle battery, the following warnings must be ob-
■
served » page 149.
A discharged vehicle battery may already freeze at temperatures just be-
■
low 0 °C. If the battery is frozen, do not carry out a jump start with the bat-
tery of another vehicle – There is a risk of explosion and injury!
Never jump-start vehicle batteries with an electrolyte level that is too low
■
– There is a risk of explosion and caustic burns!
» page 152.
144.
Jump-starting using the battery from another vehicle
Fig. 178 Jump-starting:  - Discharged battery,  - power-supplying bat-
tery / ground point of the engine for the START-STOP system

Read and observe
163
If, because of a discharged battery, it is not possible to start the engine, the
battery of another vehicle can be used to start the engine. To do this, jump-
start cables are required which have a sufficiently large cross-section and in-
sulated terminal clamps.
The rated voltage of the two batteries must be 12 V. The capacity (Ah) of the
power-supplying battery must not be significantly lower than the capacity of
the discharged battery.
The jump-start cables must be attached in the following sequence.
›
Attach clamp to the positive terminal of the discharged battery.
1
›
Attach clamp to the positive terminal of the power-supplying battery.
2
›
Attach clamp to the negative terminal of the power-supplying battery.
3
›
For vehicles with the START-STOPsystem, attach clamp
of the engine » Fig. 178.
A
›
For vehicles without the START-STOPsystem, attach clamp
metal part firmly attached to the engine block or directly to the engine block.
Starting engine
›
Start the engine on the vehicle providing the power and allow it to idle.
›
Initiate the starting process in the vehicle with the discharged battery.
›
If the engine does not start within 10 s, then cancel the starting procedure
and repeat after half a minute.
›
Remove the jump start cables in the reverse order as attachment.
on page 163 first.
Emergency equipment and self-help
to the earth point
4
to a solid
4

163