Skoda Yeti Owner's Manual page 102

System settings

Read and observe and
The following menu items can be selected from the Aux. heating menu item in
the MAXI DOT display (depending on the vehicle equipment).
Day of the wk. - set the current day of the week
■
Running time - Set the required running time in 5 minute increments. The run-
■
ning time can be 10 to 60 minutes.
Mode - Set the desired heating/ventilation mode
■
Starting time 1, Starting time 2, Starting time 3 - for each pre-set time, the day and
■
the time (hour and minute) can be set for switching on the auxiliary heating.
An empty position can be found between Sunday and Monday when select-
ing the day. If this empty position is selected, the activation is performed
without taking into account the day.
■ Activate - Activate pre-set mode
Deactivate - Deactivate pre-set mode
■
Factory setting. - Restore factory setting
■
■ Back - return to main menu.
Only one programmed pre-set time can be active.
The last programmed pre-set time remains active.
After the auxiliary heating activates at the set time, it is necessary to pre-set a
time again.
If the pre-set menu is closed by selecting the Back menu item or if no changes
are made on the display for more than 10 seconds, the set values are stored,
but the pre-set time is not activated.
An indicator light on the button is illuminated when the system is running.
The system in operation switches off on expiration of the operating duration
or can be deactivated earlier by pressing the direct on/off buttonor by using
the radio remote control.
100
Using the system
on page 99 first.
Remote control

Read and observe and
Description of the remote control
Aerial
A
Warning light
B
Switch on the auxiliary heating

Switch off the auxiliary heating

To switch the remote control on or off, hold the remote control vertically, with
the aerial » Fig. 120 pointing upwards. The antenna must not be covered
B
with the fingers or the palm of the hand during this process.
The auxiliary heating can only be switched on/off safely using the remote con-
trol if the distance between the radio remote control and the vehicle is at least
2 m.
Display warning light
B
Lights up green for 2 seconds.
Lights up red for 2 seconds.
Slowly flashes green for 2 seconds.
Quickly flashes green for 2 seconds.
Flashes red for 2 seconds.
Fig. 120
Radio remote control
on page 99 first.
» Fig. 120
Meaning
The auxiliary heating has been
switched on.
The auxiliary heating has been
switched off.
The ignition signal was not received.
The aux. heating is blocked, e.g. be-
cause the tank is nearly empty or
there is a fault in the aux. heating.
The switch off signal was not re-
ceived.
