Variable Loading Floor In The Luggage Compartment (Estate); Class N1 Vehicles - Skoda Yeti Owner's Manual

Lamp charges
The lamp is supplied by three rechargeable type NiMH AAA batteries. The bat-
teries are charged continuously with the engine running (to fully charge the
battery takes approximately 3 hours).
Replace batteries » page 166.
CAUTION
The light is not waterproof, so it must be protected from humidity - otherwise
there is risk of damage.

Class N1 vehicles


Read and observe and
On class N1 vehicles, which are not fitted with a protective grille, a lashing set
which complies with the standard EN 12195 (1 - 4) must be used for fastening
the load.
Proper functioning of the electrical installation is essential for safe vehicle op-
eration. It is important to ensure that the electrical installation is not damaged
during the adjustment process or when the storage area is being loaded and
unloaded.

Variable loading floor in the luggage compartment (Estate)


Introduction
This chapter contains information on the following subjects:
Removing/fitting variable loading floor
Secure the variable loading floor in the raised position
Removing/installing the carrier rails
Using the variable loading floor with a spare wheel
The variable loading floor makes it easier to handle bulky goods and creates an
even surface when the rear seat backrests are folded forward.
The maximum permissible load of the variable loading floor is 75 kg.
on page 88 first.
Removing/fitting variable loading floor
Fig. 111 Fold up / removal variable loading floor
›
To fold together, grasp the variable loading floor on handle
direction of arrow » Fig.
1
›
Fold up the variable loading floor in direction of arrow
›
Pull on both sides of the locking levers in direction of arrow
›
Remove the variable loading floor in direction of arrow
Insertion takes place in reverse order.
Secure the variable loading floor in the raised position
93
93
94
94
›
Fold up the hooks on the fastening strip in direction of arrow
page 89.
›
Fold up the variable loading floor behind the rear back backrests.
›
Fold down the hooks in direction of arrow
the stop.
›
Support the variable loading floor on the hooks folded downwards
111.
.
2
.
4
Fig. 112
Secured loading floor in the
raised position
» Fig. 103 on page 89 as far as
3
Transport of cargo
and lift in the
A
.
3
» Fig. 103 on
1
» Fig. 112.
93