Floor Covering On Both Sides; Luggage Compartment Cover - Skoda Yeti Owner's Manual

›
To use,insert the two ends of the storage compartment into the openings in
the side trim of the luggage compartment and push the shelf down to lock.
›
To remove grasp the storage compartment on both top edges, press the up-
per corners inwards and release the storage compartment by pulling up-
wards.
›
Remove the storage compartment by pulling towards you.
CAUTION
The flexible storage compartment cannot be installed on vehicles with the var-
iable loading floor.

Floor covering on both sides


Read and observe and
You can fit a double-sided floor covering in the luggage compartment. One
side is made of fabric, the other side is washable (suitable for transporting wet
or dirty items).

Luggage compartment cover

Fig. 105 Remove the luggage compartment cover

Read and observe and
If the support straps » Fig. 105
A
the lid will raise the boot lid cover (hereafter referred to as cover).
Removing
›
Partially fold the rear seat backrests forward
of the seat backrest.
›
On both sides of the boot lid, unhook the straps
» Fig. 105.
1
90
Using the system
on page 88 first.
on page 88 first.
are attached to the boot lid, then opening
» page 73, Adjusting the angle
in the direction of arrow
A
›
Place the cover in the horizontal position.
›
Press on the two sides to the underside of the cover in the region of the
studs in the direction of arrow
C
›
Fold the slackened front part of the boot cover over the head restraints of
the rear seats.
›
Slightly tilt the cover and remove.
Fitting
›
Place the cover on the contact surfaces of the side trim panel.
›
Position the mounts on the cover
» Fig. 105.
›
Press on the two sides to the upper side of the cover in the region of the
studs .
C
The fixture must lock into place of the studs
B
gage compartment.
›
Unhook the straps on both sides of the boot lid.
A
WARNING
Do not place any objects on the cover during the trip - there is a risk of in-
jury if braking suddenly or colliding!
.
2
onto the side trim panel via pins
B
on both sides of the lug-
C
C