Skoda Yeti Owner's Manual page 129

Setting the ready position
Fig. 144 Lock unlock / pull out hand wheel and turn

Read and observe on page 126 first.
The tow bar must be set to the ready position prior to
Check the setting of the standby position.
›
Grip the tow bar below the protective cap.
›
Remove the cap from the lock.
›
Insert the key into the hand wheel lock.
›
Turn the key in direction of the arrow
A
›
Pull the handwheel in the direction of the arrow
B
tion of the arrow to the stop. The hand wheel
3
position.
Check the setting of the standby position
Fig. 145 Ready position
installation» page 127,
to the stop » Fig. 144.
1
and drag in the direc-
2
remains locked in this
B

Read and observe on page 126 first.
Correctly adjusted standby position
The locking balls can be pushed fully into the tow bar.
A

The red marking on the hand wheel is located in the green box on the
B

tow bar.
The key is in the unlocked position and cannot be removed.
 C
There is a clear gap of approx. 5 mm

tow bar.
When in the ready position, the key cannot be removed from the lock. The ball
bar is thus set ready for installation.
Assemble the ball rod
Fig. 146 Removing the cap on the rear bumper/inserting the tow bar
» Fig. 145
between the hand wheel and the
D
Towing device and trailer

127