Skoda Yeti Owner's Manual page 99

Controlling blower
The Climatronic system controls the blower stages automatically in line with
the interior temperature. However, the blower stages can be manually adap-
ted to suit your particular needs.
If the blower speed is reduced to a minimum, Climatronic is switched off.
The set blower speed is displayed above the buttonwhen the respective
number of indicator lights come on.
CAUTION
Do not cover the interior temperature sensor
Climatronic could be impaired.
Note
If the windscreen mists up, press the button. Press the button  once
■
the windscreen has demisted.
In order to ensure adequate thermal comfort, there may be an increase in en-
■
gine idle speed during operation of the Climatronic in some circumstances.
Climatronic - automatic operation

Read and observe on page 95 first.
The automatic mode is used in order to maintain a constant temperature and
to demist the windows in the interior of the car.
If the warning light in the top right corner of the button  lights up, the Cli-
matronic operates in "HIGH"-mode.
Upon pressing the  button again, the Climatronic switches to "LOW"-mode
and the indicator light in the top left corner lights up. The Climatronic uses on-
ly in this mode the lower blower speed. However taking into account the noise
level, this is more comfortable, yet be aware that the effectiveness of the air
conditioning system is reduced particularly if the vehicle is fully occupied.
By pressing the button  again, it is changed to "HIGH"-mode.
Automatic mode can be switched off by pressing one of the buttons for the air
distribution or by increasing/decreasing the blower speed. The temperature
regulation is continued.
Note
Climatronic is set to the "HIGH" mode at the factory.
» Fig. 116 - the function of the
H
Air distribution control

Read and observe on page 95 first.
The recirculation mode prevents contaminated outside air getting into the in-
terior of the vehicle. In recirculated air mode air is sucked out of the interior of
the vehicle and then fed back into the interior.
Heating and manual air conditioning system
›
To switch on press thebutton.
›
To switch off, press the  button again.
If the air distribution control is set to position  when the recirculation modes
is switched on, the recirculated-air mode is switched off.
By pressing the  button, the air recirculation also in this position can be
switched on again.
Climatronic (automatic air conditioning)
›
To turn the recirculation mode on, press the Symbol key  repeatedly until
the indicator light is lit on the left side of the button.
›
To activate the automatic recirculation mode, press the Symbol key  re-
peatedly until the indicator light is lit on the right side of the button.
The Climatronic can have a sensor that measures the air recirculation mode
and automatically turns on if there is an increased concentration of pollutants
in the incoming air.
When the pollutant concentration decreases to the normal level, the recircula-
ted air mode is automatically switched off.
If the air quality sensor does not automatically switch on the recirculated air
mode, you can switch it on yourself by pressing the button . The indicator
light lights up in the button on the left side.
To turn off the air recirculation or to deactivate the automatic air recircula-
tion, press the  button of press the  symbol button repeatedly until the
warning lights in the button go out.
WARNING
The recirculation system cannot be switched on for a longer period of time,
because no fresh air is fed through from the outside. "Stale air" may result
in fatigue in the driver and occupants, reduce attention levels and also
cause the windows to mist up. As soon as windows mist up, turn on the re-
circulation system immediately - There is a risk of accident!

97
Heating and ventilation