Skoda Yeti Owner's Manual page 98

Aux. heating and ventilation on / switch off

Switch recirculation on/off » page 97

When the function is switched on, the indicator light in the button lights up.
Information on cooling system
After pressing the button  the indicator light on the button lights up, even if
not all the conditions for the cooling system have been met. The cooling sys-
tem starts to work as soon as the following conditions have been met
» page 95.
Note
To ensure adequate thermal comfort, during operation of the manual air condi-
tioning there could be an increase in the engine idle speed in some circum-
stances.
Climatronic (automatic air conditioning)
Fig. 116 Controls the Climatronic

Read and observe on page 95 first.
Individual functions can be set or switched on by turning the dial or pressing
the corresponding button » Fig. 116.
Adjust the temperature for the left side (or for both sides)
A
▶
Reduce the temperature /

Interior temperature sensor
B
Depending on equipment fitted:
C
▶
 Switching the windscreen heater on/off
▶
 Switch the aux. heating and ventilation on/off
Adjust the temperature for the right side
D
▶
Reduce the temperature /

96
Using the system
» page 99
increase the temperature

» page 65
» page 99
Increase the temperature

Adjust the blower speed

▶
 Increase speed
▶
 Decrease speed
Switching the airflow to the windscreen on and off

Air flow to the windows

Air flow to the upper body

Air flow in the footwell

Switch the automatic recirculation on/off

Switch on/off the rear window heater

Switching automatic mode on

Switch the Climatronic system off

Switching the cooling system on/off

Switch the temperature setting in Dual mode on/off

When the function is switched on, the indicator light in the button lights up.
After the cooling system is switched off, only the ventilation function remains
active whereby the minimum temperature that can be reached is the outside
temperature.
Setting temperature
The interior temperature for the left and right side can be set separately or to-
gether.
The temperature for both sides, is set by turning the knob
indicator light in the button  is not illuminated).
The temperature for the right side is adjusted by turning the knob
dicator light in the button  is lit).
The temperature for the left side is adjusted by turning the knob
cator light in the button  is lit).
At a temperature setting below 18 ° C at the start of the numerical scale, the
symbol will illuminate, Climatronic is using Maximum cooling performance.

At a temperature setting above 26 ° C at the end of the numerical scale, the
symbol will illuminate, Climatronic is using maximum heat output.
There is no automatic temperature control in the two end positions. In the
range between 18 °C to 26 °C, an automatic temperature control takes place.
» page 97
» page 65
» page 97
» Fig. 116
A
D
A
(the
(the in-
(the indi-
