The manual start-up phase will begin once key 1 in the test keypad is pressed.
The start-up request is maintained until the generating set starts (it is not necessary to
keep key 1 pressed).
This method may not, under any circumstances, be used to turn the engine over
manually.
During the start-up phase and until the alternator voltage and speed of the generating set
stabilise, the green LED under the generating set symbol flashes and then lights up
permanently once the phase is complete.
Tests
If no faults are present, automatic mode can be activated by pressing Auto.
The test starting phase is then initiated after pressing 1 on the test keypad.
109/298