Fault Code Register
Engine Speed (Code 2.6, PID/SPN 190)
Cause
•
Engine speed too high
Starter Input CIU (Code 5.2, PPID 4/SPN 520194)
Cause
•
Shorted to minus (-)
•
Activated for too long
Stop Input CIU (Code 5.3, PPID 6/SPN 52095)
Cause
•
Short circuit to negative (-)
•
Open circuit
•
Activated for too long time
Stop Input EMS (Code 4.8, PPID 6/SPN 970)
Cause
•
Short circuit to negative (-)
•
Open circuit
Start output/Start motor relay (Code 4.6, PPID 3/ SPN 677)
Cause
•
Shorted to plus (+) or minus
(-)
•
Activated for too long
Piston Cooling Pressure (Code 6.7, PPID 8/SPN 520192)
Cause
•
Piston cooling pressure is too
low
42
Reaction
•
None
Reaction
•
The engine cannot be started
•
The engine starts immedi-
ately when ignition is turned
on
Reaction
•
Engine can only be stopped
with the auxiliary stop (AUX
STOP) on engine
•
Engine stops. A fault code is
displayed for 40 seconds and
the engine can not be started
during this time. When a fault
code is active, the engine can
be started but not stopped
Reaction
•
Engine can only be stopped
with the auxiliarystop
Reaction
•
The engine cannot be started
•
The engine starts immedi-
ately when ignition is turned
on
Reaction
•
Engine stopped
170/298
Remedy
•
After the engine has stopped,
look for the reason for the high
speed
Remedy
•
Check that connections to the
ignition key/start panel have
not been damaged
•
Check that the cable harness
to the ignition key/start panel
has not been damaged
Remedy
•
Check that the starter switch
connections are not damaged
•
Check that the ignition switch
cable is not damaged
Remedy
•
Check that the starter switch
connections are not damaged
Remedy
•
Check that connections to the
ignition key/start panel have
not been damaged
•
Check that the cable harness
to the ignition key/sart panel
has not been damaged
Remedy
•
Check that the oil pressure in
the engine exceeds175 kPa
(25.4 psi)
7748681 12-2011