No Roll Unit - Canon iPF825 User Manual

"Press OK."
Cause
The roll is empty.

No Roll Unit.

The printer has received a print job that specifies Roll
2 (Lower), but the Roll Unit is not installed.
Sheet removed.
A sheet has come out of the printer during printing.
Sheet printing is selected.
You have attempted to print a test print sheet or other printer
status information on a sheet, but no sheet is loaded.
iPF825
Cause
Cause
Cause
Error Message
Corrective Action
Follow these steps to replace the used roll with a new roll of the
same type and size.
1. Press the OK button and remove the roll.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2. Load the new roll.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
3. If no barcode was printed on the roll, specify the type of pa-
per.
(See "Selecting the Paper Type (Roll).")
4. If no barcode was printed on the roll, specify the paper
length.
(See "Specifying the Paper Length (Roll).")
5. If "Not finished printing. Finish printing remaining
jobs?" is shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the er-
ror occurred.
Corrective Action
Hold down the Stop button for a second or more to cancel
printing.
1. Turn the printer off and install the Roll Unit.
Connect the Roll Unit Cable firmly and completely.
2. Turn the printer on and resend the print job.
Corrective Action
1. Lift the Release Lever and remove the paper.
2. If "Not finished printing. Finish printing remaining
jobs?" is shown on the Display Screen, press the OK but-
ton.
Printing will resume, starting from the page on which the
error occurred.
Corrective Action
Load a sheet and try printing again.
> Messages regarding paper
→P.597
→P.601
→P.584
→P.588
→P.595
→P.596
No Roll Unit.
>
13
829