Configuring The Destination For Appletalk Networks - Canon iPF825 User Manual

*1:The object name you have specified in Name is displayed in Printer Setup Utility (or Print Center ) in Mac
OS X 10.2.8–10.4. If you use multiple printers in the same zone, assign a unique name to each printer. By
default, the network interface name is Canon NB-17FB (xxxxxx). (Here, xxxxxx is the last six digits of the
printer's MAC address.)
*2: If zones have been created on the network, enter the name of the printer's zone. If there are no zones, leave
the asterisk * entry (for the default zone) as it is. If you enter a network zone name that does not match cre-
ated zones, the printer will not be detected by Macintosh computers. Consult your network administrator for
information on zone names.
7.
Click OK to display the Network page.

Configuring the Destination for AppleTalk Networks

To print over an AppleTalk network, activate the AppleTalk protocol and configure the destination as follows.
Activating AppleTalk on the printer
Important
• By factory default, the AppleTalk protocol is disabled on the printer.
1.
Press the Menu button to display MAIN MENU.
2.
Press ▲ or ▼ to select Interface Setup, and then press the ▶ button.
3.
Press ▲ or ▼ to select AppleTalk, and then press the ▶ button.
4.
Press ▲ or ▼ to select On, and then press the OK button.
5.
Press the Online button to bring the printer online.
If any of the settings is changed, a confirmation message is displayed. In this case, press the OK button.
Important
• Be sure to complete step 5. This will activate the values you have entered.
iPF825
Network Setting > Network Setting (Mac OS X)
Configuring the Destination for AppleTalk Networks
>
10
733