Canon iPF825 User Manual page 704

Printer Parts > Control Panel
Warning
Keep Paper Size
9
Paper Size Basis
688
Roll Switching
TrimEdge Reload
Main Menu Settings
>
Setting Item
Detect Mismatch
Sht Selection 1
Sht Selection 2
Use Optimal Size
No RollSwitching
Description, Instructions
Choose Warning for notification (display of a warning
message) during printing if the paper type specified in
the printer menu does not match the paper type in the
printer driver. Choose None to continue to print without
notification. Choose Pause to have printing paused un-
der these circumstances. In this case, you can continue
printing by pressing the Online button.
Choose On to use the paper size setting as the basis for
printing instead of other settings. The margin setting of
the printer menu will be used instead of the margin set-
ting of the printer driver if the latter is smaller, which
may prevent text or images in the margin from being
printed.
Choose Off to use the printer driver settings instead.
Even if the margin setting of the printer driver is smaller
than that of the printer menu, text or images will not be
cut off. However, this requires longer paper because the
actual margin will be equal to the margin setting of the
printer driver plus the margin setting of the printer
menu.
If sheet size detection is activated, choose whether ISO
A3+ or 13"x19"(Super B) is applied when an inter-
mediate size is detected.
If sheet size detection is activated, choose whether ISO
B1 or 28"x40" (ANSI F) is applied when an intermedi-
ate size is detected.
Selects the optimal paper size to minimize the amount
of paper wasted.
Prints using the roll currently advanced on the Platen.
Specify whether to trim the leading edge of the currently
retracted roll when the roll is advanced. Cut the edge if
you are concerned about any marks left on the roll when
the roll is left in the retracted position. Selecting On will
always trim the edge when the roll is advanced from the
retracted position. Selecting Automatic will trim the
edge when the roll has been in the retracted position for
two days or more.
iPF825