Installing A Processor And Ppm - HP ProLiant DL580 Setup And Installation Manual

Installing a Processor and PPM

To install additional processors:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Server from the Rack"
in this chapter.
3. Open the rear access panel. Refer to "Opening and Removing the Access Panels"
in this chapter.
4. Remove the memory board from slot 1:
a. Disengage the locking switch (1).
b. Push the release latches inward firmly (2).
c. Lift up the ejector levers (3).
d. Pull the memory board out of the server (4).
Figure 5-16: Removing the memory board from slot 1
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
Installing Hardware Options
5-21