Opening And Removing The Access Panels; Releasing The Rear Access Panel - HP ProLiant DL580 Setup And Installation Manual

Opening and Removing the Access Panels

To open and remove the access panels:
1. Extend the server from the rack. Refer to "Extending the Server from the Rack"
in this chapter.
2. Remove the rear access panel:
a. Use the Torx T-15 tool, located on the back of the server, to turn the locking
screw on the rear access panel counterclockwise to unlock the latch (1).
b. Pull the tab on the rear access panel toward the rear of the server until it
releases (2).
Figure 5-7: Releasing the rear access panel
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
Installing Hardware Options
5-13