Locating The Simplex/Duplex Switch - HP ProLiant DL580 Setup And Installation Manual

Installing Hardware Options
Switching from Duplex to Simplex Mode
To switch from duplex to simplex mode:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Extend the server from the rack. Refer to "Extending the Server from the Rack"
in this chapter.
3. Remove the access panels. Refer to "Opening and Removing the Access Panels"
in this chapter.
4. Locate the simplex/duplex switch.
Figure 5-29: Locating the simplex/duplex switch
5. Move the switch from duplex to simplex.
6. Reinstall the access panels.
7. Restore the server to its operating position in the rack.
8. Restart the server.
9. Configure the server using the Array Configuration Utility XE (ACU-XE).
ACU-XE, a browser-based utility, helps you configure the hardware in the way
that best suits your needs. Refer to the ProLiant Essentials Foundation Pack for
additional information.
5-36 HP ProLiant DL580 Generation 2 Server Setup and Installation Guide