HP ProLiant DL580 Setup And Installation Manual page 168

•
General Failure—Could not perform the action because of a system failure.
•
No Hot-Plug Driver—The hot-plug driver is not responding. Check to be sure
the device driver CPQSBD.NLM is loaded.
•
Remove Not Supt—The Remove action is not supported for the expansion
board/slot.
•
Switch Open—The slot cannot be initialized because the switch is open. Close
the switch and try Add/Replace again.
•
Unknown Slot—The Add/Remove was performed on an unknown slot. Try the
command again.
•
Replace Load Driver—The expansion board is successfully replaced. Please
load the driver at this time.
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
PCI-X Technology
7-27