Installing A Processor - HP HPE ProLiant DL365 Gen10 Plus Server User Manual

Installing a processor

Installing a processor
Hewlett Packard Enterprise recommends identifying the processor and socket components before performing this procedure.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-20 Torx screwdriver
1.0 gm (0.5 ml) or two 0.5 gm (0.25 ml) of thermal grease
Alcohol wipe
Procedure Procedure
1. Observe the following alerts:
CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace CAUTION:
or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations CAUTION:
must contain processors with the same part number.
CAUTION: If installing a processor with a faster speed, update the system ROM before installing the processor. CAUTION:
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support Center
website. website
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket or
processor, do not touch the contacts.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
5. Remove the access panel .
6. Remove the air baffle
7. Remove the heatsink blank.
8. Use a T-20 Torx screwdriver to loosen the three captive screws in the sequence shown in the following image, and then pivot the
force frame upward.
Hewlett Packard Enterprise Support Center
Installing a processor 121