Installing The Processor - HP NetServer LH 6000 Installation Manual

All manuals and user guides at all-guides.com
Chapter 7
CAUTION Before you remove a processor from the anti-static container,
touch a grounded, unpainted metal surface on the HP
NetServer to discharge static electricity.
Do not change the processor speed switches as this can result
in unreliable or intermittent performance, and data integrity
may also be at risk.

Installing the Processor

The installation procedure is the same for the rack-mount and the pedestal
NetServer once you gain access to the system board assembly.
1. Log off all users and gracefully shut down the network operating system
according to directions in your NOS documentation.
2. Power down the NetServer according to the instructions in Chapter 2,
"Controls, Ports, and Indicators."
3. Disconnect the power cords and cables and, if necessary, label each one to
support re-assembly.
CAUTION
The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.
4. For both rack-mounted and pedestal models, follow the instructions in
Chapter 3, "Opening and Closing the HP NetServer," to gain access to the
system board assembly.
NOTE
In the LH 6000r, this assembly is under the right cover; in the
LH 6000, it is under the top cover.
5. Remove the system board assembly from the chassis.
CAUTION
The System Board Assembly weighs approximately 20 lbs.
(9 kgs). Support it at the bottom as it is removed from the
chassis.
72
Installing Additional Processors