Installing A Second Processor; Introduction; Tools Required; Installation Steps - HP NetServer E 60 Installation Manual

7 Installing a Second Processor

Introduction

The NetServer E 60 supports up to two processor modules. Processor modules are
available at different clock speeds.
The HP NetServer E 60 supports either Pentium II or Pentium III processors. Do
not mix Pentium II and Pentium III processors in the system. Do not mix
processors with different clock speeds in the system (example: 400MHz and
450MHz processors).
Note that compatible processors are not necessarily identical in appearance.

Tools Required

This tool is required for removal and installation of CPU modules:
•
An anti-static service kit (3M™ 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.

Installation Steps

Open the NetServer E 60

1. If the system is already installed and working, gracefully power down the
system as described in Chapter 2.
2. Disconnect the power cables and any external cables connected to the
system. If necessary, label them to expedite reassembly.
3. Remove the cover and turn in the system feet (so that the system will lay
flat on its side) as described in Chapter 3.
4. Lay the server on its side (components showing).
5. Unsnap the air duct and move it out of the way (refer to Figure 4-1).
WARNING
The power supply will continue to provide standby current to
the NetServer until the power cable is disconnected.
41