Marking The Rack For Server Installation - HP ProLiant DL580 Setup And Installation Manual

4. Using a pencil, mark the locations on the rack where you insert the rack rail
tabs (1).
5. On the rack, mark the top and bottom edges of the template (2). This step helps
you align a template for the next component.
Figure 8-2: Marking the rack for server installation
6. Move to the rear of the rack and turn the template over so you can use the
backside of the template.
7. Repeat steps 2 through 5 with the back of the template on the rear of the rack.
IMPORTANT: On the rear of the rack, make pencil marks on the inside of the vertical
rails. These markings guide you in installing rack rails into the interior of the rack frame.
8. Remove the template from the rack.
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
Installing the Server in a Rack
8-5