JUMO LOGOSCREEN Operating Manual page 65

Status
messages
Status messages of the CompactFlash card menu are shown in a separate
window in the menu.
D
- If you use the
automatically terminated.
E
- If you use the
the CompactFlash menu continues to be active.
The following status messages are possible:
Status message
Action successfully
completed.
Action canceled.
No card in disk drive!
Not enough memory available
on card!
Card is write-protected!
Card is not
DOS-formatted!
General error!
No config. data on
the CompactFlash card
found!
No user list on
the CompactFlash card
found!
3 Operation and visualization
key to confirm a message, the CompactFlash menu is
key to confirm a message, only the message is deleted,
Description
Directly before removing the CompactFlash card
from the instrument, it is necessary to call up
Update CF card so that all measurement data up to
the time of removal are contained on the
CompactFlash card. The data not yet stored since
the last automatic saving are written.
This message is shown when accessing the
CompactFlash card has been canceled by activating
the
Access to the CompactFlash card was attempted,
even though there is none in the instrument.
The CompactFlash card is full. No more data are
written.
Remedy: Insert a blank CompactFlash card before
the measurement data memory of the recorder is
also full. If this is not done, measurement data will
be lost.
The inserted CompactFlash card cannot be written
to because it is write-protected.
An error has occurred while writing to the
CompactFlash card, because it was wrongly
formatted or not formatted at all.
Remedy: Format the CompactFlash card.
An error has occurred while writing to the
CompactFlash card. The CompactFlash card may
be faulty.
Remedy: Insert new (DOS-formatted) CompactFlash
card.
You start the function CF card
there are no configuration data on the
CompactFlash card.
Remedy: Check card on PC and generate data
again, if necessary.
You start the function CF card
is no user list on the CompactFlash card.
Remedy: Check card on PC and generate list again,
if necessary.
button.
Config. data and
User list and there
65