Data Transfer; Extras - JUMO LOGOSCREEN Operating Manual

5 Setup software

5.8.3 Data transfer

Make
connection
Break
connection
Data transfer to
device
Data transfer
from device
Data export to
CF card
Data import
from CF card

5.8.4 Extras

H
Enable program
options
Enable extra
codes
112
This function establishes a connection to a device. A connection to a device is
a precondition for transferring a setup to or from a device via an interface
(serial or Ethernet).
Breaks an existing connection. A connection to a device must be broken
before a new connection can be established to another device.
Transmits a setup to a device.
Reads in a setup from a device. If there is no connection, the software will
automatically attempt to access the default device.
The setup will be saved on a CompactFlash card. The CompactFlash card can
be read by the device.
Reads a setup from a CompactFlash card, and displays it in the working area.
All the functions in the Extras menu which require access to a
device must have a connection to the device.
If there is no connection, the setup software will try to access the
default device from the device list. If no default device has been
defined, then the device list will appear on the screen and the user
must set up a connection by hand.
If no valid serial number was entered during the installation of a program, then
it will only run in demo mode, and some functions, e.g. "save", will be blocked.
This function can be used to register a program at a later date and so change
it from a demo version into a full version.
This function is intended for later extensions within the paperless recorder.
After starting up the function, a code number must be read out from the
device, using the
manufacturer. The manufacturer will then produce a "release" number. The
button is used to transmit this release number to the device,
which then enables the new device function.
button, and then passed on to the