JUMO LOGOSCREEN Operating Manual page 21

Event operation
Example
The digital signals can be used to activate event operation. In event operation,
the measurements are stored with a storage cycle that is different from normal
operation.
When the available internal memory (during read-out through the
CompactFlash memory card) falls below 1Mbyte, the storage cycle of the
measurements for group 1 should be set to 20sec.
The following have to be configured:
Parameter
Configuration
Device data
Storage alarm
Int.mem./read-out via CF
Configuration
Group config.
Group 1
Event operation
Control signal
Configuration
Group config.
Group 1
Event operation
Storage cycle
2 Instrument description
Value/setting
1MB
Int. mem. al./CF
20[s]
21