Transfer Via Interface - JUMO LOGOSCREEN Operating Manual

5.6.2 Transfer via interface

Setup - RS232C
RS232C
RS422/485
Ethernet
H
Starting the
transfer
Data transfer via interface is possible via one of the following interfaces:
Paperless recorder
Setup interface
RS232C
RS422 / 485
Ethernet
v The setting for the interface parameter can be found in Chapter 4.2 "Table
of configuration parameters".
You will need the interface cable (including adapter) here. It is available as an
accessory to the recorder.
TTL/RS 232
converter
v For the pin assignment, please refer to the Interface Description
B 70.6570.2.0.
v For the pin assignment, please refer to the Interface Description
B 70.6570.2.0.
The recorder or the PC can be connected to the network using the usual
network cables (RJ45 connector). If the recorder and a PC are to be directly
connected, please use a crossover cable.
Only one 1 PC (client) at a time can access the device (server) via
the Ethernet interface.
Use the toolbar or the Data transfer menu with its functions "Data export to
device" and "Data transfer from device" in order to transfer the setup data.
PC
RS232C
RS232C
RS422/485
(plug-in card or converter)
Ethernet
PC
Data transfer from device
Data transfer to device
5 Setup software
Device
Adapter
103