JUMO LOGOSCREEN Operating Manual page 106

5 Setup software
TCP/IP PORT
Analog
modem /
ISDN
106
The next steps depend on which interface or type of connection has been
selected.
The following parameters must be selected.
IP address /
HOST name
Port number,
port name
Communication
protocol
The following parameters must be selected.
Telephone number
Connect via
Communication
protocol
Device address
xxx.xxx.xxx.xxx
(Example: 10.11.2.100)
502
Modbus TCP/IP,
Modbus protocol
Modbus TCP/IP,
Modbus protocol
1 — 255
Enter the IP address of
your device. If you enter
the name, the IP
address can be
determined by clicking
on the button "Convert
HOST name to IP
address".
The port used for
communication.
Modbus TCP/IP must
be set here.
Enter the telephone
number for the required
device.
Select the modem that
is to be used to make
the connection.
Modbus protocol
must be set here.
Device address for the
Modbus protocol.