JUMO LOGOSCREEN Operating Manual page 114

5 Setup software
Ethernet
interface
A
Write interface
texts
H
114
This function transmits an Ethernet configuration to a device. It does not
matter how the device is connected to the PC. Transmission via a serial
interface is also possible.
If a device is already connected via an Ethernet link, then the
function can be used to alter the Ethernet configuration in the
device. The Ethernet data in the device list are now incorrect, i.e.
you must now edit the device setting in the device list.
The Ethernet configuration is not controlled through the dialog window in the
setup software, but only here, in the Extras menu.
This function can be used to transmit batch texts, recipes and a message text
to a device.
Batch texts are used to describe a batch report. The batch texts can only be
written, if the contents of the right column of a text has been configured as an
interface text.
Recipes are used to describe a batch. Recipes can only be entered through
the Extras menu, and then transmitted to a device. Recipe data are evaluated
by the PC Evaluation Software PCA3000.
The message text can be used to make an entry in the event list for a device.
The functions are independent of the latest setting in the dialog window. The
data can be transmitted to a device, without causing a new configuration.
In order to be able to write interface texts, rights exist on the de-
vice side, as well as on the PC side (special case).
The device right "Enter batch texts" is available in the device as a
factory default right.
The message text for the event list also incorporates a right on the
device side ("Write Teleservice (comments...)").