Lens Installation - Christie E SERIES User Manual

Section 3: Installation
3.7

Lens Installation

Lens installation and replacement should be completed by Christie accredited service
personnel only. When handling the projector after lens installation, make sure the
front lens cap is placed on the lens to protect the lens surface from potential damage.
When carrying or moving the projector, do not handle by the lens. This may damage
the lens, the chassis or other mechanical parts within the projector.
Installation Steps:
1. Center the lens:
Ensure that the lens is at or near
its center position. Attempting to
remove the lens when at a large
offset may cause damage to the
lens assembly. Center the lens
while the projector is switched on
by pressing the lens horizontal or
vertical button and then pressing
Enter.
2. Turn off the projector:
Turn the projector OFF and
disconnect the power cord.
3. Wait for projector cool down:
Allow the projector to cool down for
at least 1 minute before replacing
the lens.
4. Open the lens door:
Push and open the lens door located
on the top-front of the projector.
5. Remove the lens:
Push the release lever up to release
the lock. (Figure C-1) Remove
the lens through the front of the
projector.
6. Remove the lens cap (1):
Remove the rear lens cap from the
lens. Keep the front lens cap on the
lens to protect it during installation.
7. Install the new lens:
Align the lens interface plate with
the lens mount. Fully insert the
assembly straight into the lens
mount without turning.
Push the release lever down to lock
the lens in place.(Figure C-2)
8. Close the lens door:
Lower the Lens Door and slide back
into the secured position.
9. Remove the lens cap (2): Remove
the front lens cap.
3-10
Downloaded from ProjectorsManual.com Manuals
A
B
C-1
D
C-2
E Series User Manual
020-000287-01 Rev. 1 (01-2011)