JUKI HZL-F series Instruction Manual page 21

Name and function of operational buttons
Zigzag width
adjustment dial
1
* buttons on F400/F300.
Stitch length
adjustment dial
2
* buttons on F400/F300.
Confirmation
3
button
Selection button
4
Clear button
5
Automatic lock
stitch and thread
6
trimming button
Needle stop
position
switching button
7
Continuous
stitch button
8
Mirror Image
9 button
Option button
!0
Save/call button
!1
Pattern selection
button
!2
Pattern selection
mode switching
!3
button
This is used to change the zigzag width and the needle position.
This is used to change the stitch length.
This is used to confirm the selected stitch pattern and/or settings.
This is used to move the cursor.
This is used to delete the selected stitch pattern and to cancel each setting.
When pressing the button continuously, all the saved stitch patterns will be
deleted.
When it is pressed, symbol "
The machine will automatically lock stitches at sewing-start and sewing-end
and then trim both threads.
When it is pressed, either symbol "
When sewing with symbol "
When sewing with the symbol "
This button is valid only when "
When it is pressed, symbol "
The machine will sew the selected stitch patterns continuously.
When it is pressed again, the machine will cancel this function.
* When it is pressed while sewing, the machine will stop after the selected
patterns are sewn completely.
After selecting a stitch pattern, press this button to make a mirror image of the selected
pattern.
* There are some patterns that can not make a mirror image.
It is possible to change the following function and settings.
・Seam width of buttonhole
・Thread trimming by foot controller
・Guide
・Buzzer volume
・Elongation
* Optional functions vary from stitch pattern to stitch pattern.
(Refer page 126~138 for more details.)
This is used to save and/or call a pattern. The machine can save maximum 10 patterns.
(Refer to page 123 and 124 for more details.)
A stitch pattern can be selected.
* Usage of the buttons varies by pattern selecting mode.
(Refer to page 51~62 for more details.)
When the pattern selection mode needs to be changed, press the desired button. The
selected button will be illuminated.
" will be shown on the screen.
" or " " will be shown on the screen.
", the needle stops at its highest position.
", the needle stops at its lowest position.
" mode.
" will be shown on the screen.
・Needle position
・Twin needle
・LCD display contrast
・Language
20