5.25-Inch Device - NEC 140He User Manual

9-14

5.25-inch Device

The server contains two slots in which SCSI backup devices such as magnetic tape drive can be installed.
Slot #2
Slot #1
Available Devices
The 5.25-inch device slot can contain two single-height SCSI devices, or one full-height device.
To connect the 5.25-inch device with the on-board SCSI controller, connect the SCSI cable mounted on the
5.25-inch device bay to "Ch-B" of SCSI connector on I/O board. In this case, assign the SCSI ID between 0
and 6 for the device to be installed. Set the terminator to "Disabled".
If the "Ch-B" of SCSI connector on I/O board is connected to the additional HDD cage, connect the 5.25-inch
device to the optional SCSI controller board.
Setting of SCSI ID
When connecting the 5.25-inch device with the SCSI connector (Ch-B) on I/O board, set the SCSI ID 0 through 6.
When connecting the 5.25-inch device with the optional SCSI controller, refer to the manual that comes with the SCSI
controller.
Setting of terminator
Set the terminator to "OFF".
Installation
Described below are installation procedures for both IDE device and SCSI device.
For SCSI device, procedures for connecting the device to SCSI connector "Ch-B" on I/O board are explained here. To
connect it to the optional SCSI controller board, see "Cable Connection" described later.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Open the front door.