Upgrade Installation - NEC 140He User Manual

Upgrade Installation

NOTE:
If you are using the Adaptec 29160, please carry out after removing it.
1.
Procedures below upgrade the installed Windows 2000 to Windows Server 2003.
2.
Power on the system and start Windows 2000.
3.
Log on as an administrator.
4.
Insert the Windows Server™ 2003 CD-ROM into the CD-ROM drive.
Then, [Select an operation] dialog will be displayed.
NOTE:
If the [Select an operation] dialog box is not displayed, start \SETUP.EXE from
CD-ROM drive.
5.
Select [Install Windows Server 2003].
Then, a dialog box asks to select upgrade or clear installation.
6.
Select "Upgrade (recommended)" and click Next.
Follow the messages and continue. The system will automatically restart after copying the files.
NOTE:
You can leave the Windows Server 2003 CD-ROM in the CD-ROM drive.
7.
If a disk array controller is attached to the device, press F6 while a message, "Setup is inspecting your
computer's hardware configuration...", is on the screen.
IMPORTANT:
8.
When the following message is displayed, press S.
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage device(s).
The following message is displayed.
Please insert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
*Press ENTER when ready.
9.
Insert the Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER into the floppy disk drive, and
press Enter.
A list of mass storage devices is displayed.
Select the [LSI MEGARAID Products for Windows 2003 (x86)] and press Enter.
10.
Update the system.
There is no visible indication on screen when F6 has been pressed.
E-7