Table of Contents
Advertisement
REMOTE MANAGEMENT FUNCTION
Remote Management Function enables your system to monitor the status of power supply unit, fan and temperature of
servers by BMC (Baseboard Management Controller) and a remote KVM (Keyboard, Video, Mouse) console feature by
communicating through a management LAN PORT feature.
NOTE:
The screen which can be displayed by the remote KVM side becomes resolution
1024x768 and less than refresh rate 75Hz.
Since a screen is not displayed by remote PC when a setup beyond this is performed, please
set it as less than this.
Moreover, if many numbers of colours of a screen are set up, an exact colour may be unable
to be displayed by remote PC.
When your server is connected to the network where broadcasting occurs frequently, the
performance about remote control may be affected.
Default Network Settings
When linking the management LAN port at the rear of the server to a network, refer to the following for default
settings.
Using a DHCP function, the host name in the case of performing automatic registration to a DNS server turns
into the above-mentioned host name.
Host Name: ARMCXXXXXXXXXXXX, where the 12 Xs are the MAC address of the Management Card.
When you link without a DHCP server, please access the above-mentioned IP address in the local network
which can use a default IP address "192.168.1.1."
NOTE:
For security reasons, change these default settings (Password, an IP address, host
name) by your network environment. See "BMC Configuration" described later for the
setting method.
Server Setup
This section explains the operations which must be carried out on the server side, when using the Remote Management
Feature.
Initial Setup
To use the Web server feature, change settings as shown below.
Start the EXPRESSBUILDER from CD-ROM, and select [System Management] → [Set Advanced Remote
Management Card] from the Tools menu.
On the [Set Advanced Remote Management Card], select [Remote Management Console] → [Enabled], and then select
[Register].
IMPORTANT:
IP Address : 192.168.1.1
User Name : administrator
Password
: (None)
Host Name : ARMCXXXXXXXXXXXX
For security, the Web server feature of BMC is disabled at the shipment.
4-49
Advertisement
Table of Contents
