NEC 140He User Manual page 150

140he
Table of Contents

Advertisement

4-78
Pins for protecting/clearing the passwords
Short-circuit these two pins to clear the passwords.
Open these two pins to protect the passwords (factory-set).
Pins for protecting/clearing the CMOS data
Short-circuit these two pins to clear the CMOS data.
Open these two pins to protect the CMOS data (factory-set).
6.
Reassemble the server and press the POWER switch.
7.
When the POST screen appears, power off the server and unplug the power cord.
8.
Restore the jumper switch setting.
NOTE:
Place the clip over the jumper pins 11 and 12 after use to keep the pin. Placing the
clip over any other pins may cause malfunction of the server.
9.
Reassemble the server and press the POWER switch.
10.
Run BIOS setup utility and restore the parameter settings recorded in Step 1.
If you have cleared the password, set it again as needed.
11.
Save and exit the utility.
Pins 11 and 12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Express5800/140heNec express5800 series

Table of Contents