Relocating/Storing The Server - NEC 140He User Manual

7-8

RELOCATING/STORING THE SERVER

Follow the procedure below to relocate or store the server:
Observe the following instructions to use the server safely. Failure to follow these instructions
may cause a fire, personal injury, or property damage. See pages 1-3 to 1-8 for details.
Never attempt to lift the server only by yourself.
Do not install the server in any place other than specified.
Do not connect/disconnect any interface cable with the power cord of the server plugged to
a power source.
IMPORTANT:
If the server needs to be relocated or stored due to a change in the floor layout to a great
extent, contact your service representative.
Make sure to make a backup copy of your valuable data in the hard disk, if any.
Make sure not to apply a shock to hard disks when relocating the server if it contains
any.
It is recommended that the server and the internal devices should be stored in a place
where the room temperature can be maintained. It is important for the server or internal
devices to work normally after storage. Store the device in a place where temperature
ranges between -10 to 55ºC and humidity ranges between 20 to 80% without dew
condensation.
If you use the server after transported or relocated, check the system timer and adjust it
if necessary. If the system timer advances or delays remarkably with the passage of time,
contact your service representative to repair it. The server or internal option device may
be dewed if it is brought to a warm place from a cold place suddenly. Using a server or
an internal device with dew attached may cause malfunction or failure. Make sure to
adapt them to the operating environment before using them.
1.
Take floppy disk and CD-ROM out of the server, if any.
2.
Power off the server (the POWER lamp goes off).
3.
Unplug the power cord of the server from a power outlet.
4.
Remove all the cables from the server.
5.
Hold the server by its bottom with at least four persons to carry the server.
6.
Protect the server with the shock-absorbing materials, and pack it securely.
CAUTION