NEC 140He User Manual page 158

5-8
[Using the existing Configuration Disk]
The parameters files in the floppy disk are listed in dialogue-box.
1) Select a parameters file to use in the Express Setup, and then click [Use].
After the parameters file is specified, the message "Do you want to review or modify the Setup File
parameters?" appears.
2) If you want to modify or confirm the parameters file, click [Review]. If not, click [Skip].
Click [Review] → Go to next step.
Click [Skip] → Go to step 10.
[Using a blank disk]
1) Click the box under [Setup File Name: (A)] or press A.
The dialog box appears.
2) Type the file name and click [Use].
9.
Confirm or modify the parameters of disk array configuration.
[Configure RAID] screen appears. Confirm the specification, modify if necessary, and then click [OK].
NOTE: Choose RAID0 when you install it in one hard disk.
When the dialogue-box is closed, the Express setup automatically performs the RAID configuration, creating
Maintenance partition and installing several utilities.
10.
Select the installing Operating system.
Select "Windows" from the menu.
11.
Select the Windows family.
Select "Microsoft Windows Server 2003 Standard Edition / Microsoft Windows Server 2003 Enterprise
edition" category.
NOTE: If you selected "Skip" at step 8, this menu does not appear, go to step 13.
12.
Next, [Basic Information] wizard appears. Confirm the parameters, modify if necessary, and then click [Next].
After that, click [Next], [Back], or [Help] to continue. Modify the parameters each time necessary.
IMPORTANT:
Reserve the partition to install the operating system more than the minimally required
size.
If you select "Use Existing Array" at "New/Existing RAID Configuration", the
information included in the first partition (excluding maintenance partition) will all be
formatted and deleted. The information included in the other partition will be retained.
The figure below describes the partition which information will be deleted when
maintenance partition exists.
You cannot re-install the system with the existing partition that is upgraded to
Dynamic Disk remained. Do not select "Use Existing Array" at "New/Existing RAID
Configuration".
If you specify other than 4095 MB for the "Installing Partition", it is necessary to
convert to NTFS.
If "Use Existing Array" at "New/Existing RAID Configuration" is selected but the
partition other than the one to install Windows Server 2003 does not exist (excluding
First Partition
<Maintenance Partition>
Retained
Second Third Fourth
Partition Partition Partition
Deleted Retained Retained