NEC 140He User Manual page 154

140he
Table of Contents

Advertisement

5-4
Optional Board Supported by EXPRESSBUILDER
EXPRESSBUILDER CD-ROM attached to your system supports the following optional boards:
NOTE: If you want to install the other boards except ones listed below by using a driver
floppy disk ("OEM-FD for Mass storage device"), see "Exceptional setup" and "Installing
Optional Mass Storage Driver" of "Configuration Diskette Creator" in Chapter 6.
Supporting installation of operating system in EXPRESSBUILDER
– On Board RAID (Controller on the I/O board)
– SecuRAID 321 Disk Array Controller (SCSI 2ch)
Other optional boards
– Initio 101 SCSI Controller
– Adaptec 29320 SCSI Controller
– SCSI U160 PCI-ATX-64b 1 Disk Controller
IMPORTANT: If you want to set up for the SecuRAID 321, you cannot use "Express
Setup". See Appendix E, and set it up.
Windows Server 2003
Express Setup can install Windows Server 2003 operating system. However, note the following issue:
IMPORTANT:
Before starting the installation, complete all the process of adding the optional device
and the setup of Express server mainframe (BIOS and optional board specification)
A document for installing Windows Server 2003 is also attached to the other software
package which is sold separately, but refer to this document when you install Windows
Server 2003 on this model.
After completing Express Setup, see "Setup for Solving Problems" described later to
specify the settings for trouble recovery such as "Specifying Memory Dump".
Installing on the Mirrored Volume
If you want to install Windows Server 2003 on the volume that is mirrored using "Disk Management", invalid the
mirroring before operating the installation to set back to the basic disk, and valid the mirroring again after the
installation has completed.
Creating, invalid, delete mirror volume can be operated from "Disk Management" in "Computer Management".
Connecting MO Device
If you are installing Windows Server 2003 with MO device connected, the installation may not be completed normally.
In such case, disconnect the MO device and then re-install the system from the beginning.
Media such as DAT
During the operating system installation, do not attach the unnecessary media for operating system installation to the
system, such as DAT.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Express5800/140heNec express5800 series

Table of Contents