NEC 140He User Manual page 241

Cannot turn the power OFF at the blue screen:
→ If you want to turn off the power at the blue screen, execute forced power off (forced shut down:
continue to press POWER switch for 4 seconds). The power will not be turned off if you press the
switch just one time.
The server is not found on the network:
•
Is the LAN cable connected?
→ Make sure to connect the LAN cable to the network port on the rear of the server. Also make sure that
the LAN cable to use conforms to the network interface standard.
•
Is BIOS configuration correct?
→ The internal LAN controller may be disabled with the BIOS setup utility of the server. Check the
setting with the BIOS setup utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Embedded NIC 1], [Embedded NIC 2]>
•
Have the protocol and service already be configured?
→ Install the distinctive network driver for the server. Make sure that the protocol, such as TCP/IP, and
services are properly specified.
•
Is the transfer speed correct?
→ Open the network property dialog box in control panel to specify the "Link Speed & Duplex" value
the same as the value specified for the HUB.
The processor name displayed in [General] tab of [System Property] is not in correct position.
→ There is no problem for operation.
The system displays the message below and fails to log in.
→ In Windows Server 2003, the following message will be displayed if you use the operating system
without executing the license authentication. Select "Yes", and execute the procedure for license
authentication.
Unable to update the system:
•
Are you trying to update the system without applying Service Pack or with Service Pack 1, 2, or 3?
→ Without applying Service Pack and applying Service Pack 1, 2, or 3 to this system are not supported.
You have to apply Service Pack 4 to update the system.
If you use Windows 2000 CD-ROM which includes Service Pack 4 to install Windows 2000 on your
system, you do not have to apply Service Pack 4 again when you update the system.
Windows Product Activation
This copy of Windows must be activated with Microsoft before you can
continue, You cannot log on until you activate Windows.
Do you want to activate Windows now?
To shut down the computer, click Cancel.
YES NO Cancel
8-37