NEC 140He User Manual page 166

5-16
4.
Specify "Complete memory dump" and modify [Dump file:] in the
[Write debugging information] group box.
e.g. Write the debug information in D drive write the file name "MEMORY.DMP".
D:\MEMORY.DMP
5.
Click [Settings] on the [Performance] group box.
The [Performance Options] window appears.
6.
Click [Advanced] tab on the [Performance Options] window.
7.
Click [Change] on the [Virtual memory] group box.
8.
Modify [Initial Size] in the [Paging file size for selected drive] box to a value larger than [Recommended],
and click [Set].
IMPORTANT:
The above-mentioned paging file size is recommended for collecting debug
information (memory dump). The paging file with initial size large enough to store the
dump file in the boot drive is required.
Correct debug information might not be able to be collected due to virtual memory
shortage when the paging file is insufficient, so set the paging file size large enough
for the entire system.
For more information on "Recommended" value, see "Partition Size to be Created"
described earlier.
In case the memory is expanded, re-specify the paging file to suit the new memory
size.
To prepare for the situation when any trouble occurred, we recommend you to press
dump switch to confirm that the dump will be collected normally in advance.
9.
Click [OK].
The message to restart the system may appear according to the modified specification. In such case, follow
the message to restart the system.