NEC 140He User Manual page 52

2-24
3.
Displays the SCSI ID numbers used by the connected SCSI devices on the screen.
4.
If one or more disk array controllers are installed, displays the message prompting you to start the Disk Array
BIOS setup utility.
Start the utility according to the message if you need to change the settings. Refer to the manuals of the disk
array controllers for details.
Without any entry, any of the following messages appears.
Notes when pressing Ctrl and any other keys during POST:
When you press Ctrl and any other keys during POST to start configuration utility or others, the key entry
rarely becomes invalid. If it occurs, press Ctrl again to resume the operation.
5.
Displays the message notifying you the detection of the processor and the connected keyboard and mouse.
6.
Displays any of the following messages.
Pattern 1:
Press <F2> to enter SETUP or <F12> to Network
Pattern 2:
Press <F2> to enter SETUP, <F4> Service Partition, <F12> to Network
Or Pattern 3:
Press <F1> to resume, <F2> to enter Setup, <F12> to Network
Pattern 4:
Press <F1> to resume, <F2> to enter Setup, <F4> Service Partition, <F12> Network
* The displayed message may vary depending on the device status.
NOTE:
The operation or utility to be started at each key entry is described below. These
operations or utilities may not always be started.
Esc
Press Esc to display the boot menu at the end of POST. This menu allows you to select
the device to boot from.
F2
Press F2 to start the BIOS setup utility. Start the utility to change the setting of the
server to that fit to the environment in which the server is used. In general, the setting
may not be particularly changed by starting the utility excluding the case in which the
previous message accompanied by an error message appears. See Chapter 4 for setting
procedures and features of the parameters.
F4
Press F4 to start the Off-line Maintenance Utility from the maintenance partition. See
Chapter 6 for the maintenance partition.
F12
Press F12 to run the network boot.
Boot Menu
1. CD-ROM Drive
2. +Removable Devices
3. +Hard Drive
4. IBA GE Slot 0B20 v1222
5. IBA GE Slot 0B21 v1222
<Enter Setup>