Table of Contents
Advertisement
Hot Add
Take the following procedure to execute Hot Add:
1.
Remove the rear access cover from the server with the power being on.
2.
Locate the slot in which you are going to install an additional board.
NOTE:
Confirm that the PCI Slot Power lamp of the slot in which you are going to install
the PCI board is off.
3.
Push the tab at the tip of the additional slot cover of the slot in which you are going to install the PCI board to
unlock the tab. Open the tab.
IMPORTANT:
damage the tab.
4.
Remove the slot cover.
IMPORTANT:
Do not open the retention tab to 90 degrees or more. Doing so could
1
Keep the removed slot cover for future use.
2
9-29
Advertisement
Table of Contents
