System Monitor - Canon imaqeRunner 1019J Advanced Operation Manual

Advanced Send
1
Features
Advanced Copy
Features 2
Network
3
Remote UI
4

System Monitor

5
System Manager
Settings 6
Reports and Lists
7
Troubleshooting
8
Appendix
9
Table of Contents
Index
30.
Press [Additional Functions] so that <PORT
NO.> in <TCP/IP SETTINGS> is displayed.
31.
Press [ ] or [ ] to select <SET IP ADD
RANGE>, then press [OK].
32.
Press [ ] or [ ] to select <ON>, then
press [OK].
33.
Confirm that <PERMIT/REJECT> is
displayed, then press [OK].
34.
Press [ ] or [ ] to select <REJECT> or
<PERMIT>, then press [OK].
<REJECT>: Restricts the IP addresses of computers from which
data (print/fax job) can be sent to the machine.
<PERMIT>: Permits the IP addresses of computers from which
data (print/fax job) can be sent to the machine.
35.
Confirm that <SET IP ADDRESS> is
displayed, then press [OK].
36.
Press [ ] or [ ] to select from <IP
ADDRESS 1> through <IP ADDRESS 4>, then
press [OK].
Back Previous
37.
Confirm that <START IP ADDRESS> is
displayed, then press [OK].
38.
Use the numeric keys to enter the start IP
address, then press [OK].
39.
Confirm that <END IP ADDRESS> is
displayed, then press [OK]
40.
Use the numeric keys to enter the end IP
address, then press [OK].
NOTE
To enter another IP address range, repeat step 36 to 40. After
you specified the <END IP ADDRESS> of <IP ADDRESS 4>,
confirm that <RX MAC ADD SET.> is displayed, press [OK],
then skip to step 43.
41.
Press [Additional Functions] so that <SET IP
ADD RANGE> in <TCP/IP SETTINGS> is
displayed.
42.
Press [ ] or [ ] to select <RX MAC ADD
SET.>, then press [OK].
TOP
Next
3-17