Canon imaqeRunner 1019J Advanced Operation Manual page 189

Advanced Send
1
Features
Cannot receive a document manually.
Advanced Copy
Features 2
Network
3
Remote UI
4
System Monitor
5
System Manager
Settings 6
Reports and Lists
7
Troubleshooting
8
Appendix
9
Table of Contents
Index
Q Is the machine set to receive manually?
A For the machine to receive faxes manually, the
receive mode must be set to <Manual>. (See
"Setting Receive Mode," on p. 1-11.)
A If you set <MANUAL/AUTO> to <ON> in <RX
SETTINGS> located in <FAX SETTINGS> in <TX/
RX SETTINGS>, the machine will receive faxes
automatically even when the receive mode is set to
<Manual>. (See Chapter 14, "Machine Settings," in
the Basic Operation Guide.)
Q Have you disconnected the call by pressing
[Start] or dialing the remote reception ID after
hanging up?
A Always press [Start] or dial the remote reception ID
before hanging up. Otherwise you will disconnect
the call.
Back
Print quality is poor.
Q Is the toner low?
A Replace the toner cartridge. (See Chapter 12,
"Maintenance," in the Basic Operation Guide.)
Q Is the correct type of paper loaded in the
machine?
A Make sure you load paper that meets the
requirements for use. (See Chapter 3, "Print
Media," in the Basic Operation Guide.)
Q Is the sender's machine functioning properly?
A Ask the sender to check that the scanning
components of the machine are clean.
Q Is the machine in the toner saver mode?
A Set <TONER SAVER MODE> to <OFF> in
<COMMON SETTINGS>. (See Chapter 14,
"Machine Settings," in the Basic Operation Guide.)
TOP
Previous Next
8-13